How to use one corner output expression in other corners for a multiple corner/sweep sim?

Hi all,

I have a simulation testbench in ADEXL which has multiple corners to run. I want to use one of corner output expression in other runs.

To give couple example for usage: I will run ss, ff and tt corners in the same simulation in parallel and scale all output currents to tt value. Or I will run schematic based netlist and dspf based post-simulation netlist in parallel. Then, I want to compare the output expression between these two for verification. This can be scalable to over PVT as well.   

I am not sure if this is possible in the same simulation since simulation finish time can be different. I am open to other ways to do these as well.

Thanks

yayla

Version Info:

ICADV12.3 64b 500.21

spectre -W =>

Tool 'cadenceMMSIM' Current project version '16.10.479'
sub-version  16.1.0.479.isr9