hello experts,
I don't think I had to do anything to annotate "Transient Operating Points" after "tran" sim from ADE-L. but now as I try to annotate, I see only Terminal's Transient Voltage/Currents can be annotated, but not "Transient Operating Points". not sure what I missed to have the simulation to save all the points.
if I use "infotimes" setting like "0 250n 500n", then I only the Transient Operating Points at those time only, not arbitrarily selectable to any other time.
IC6.1.7-64b.500.21
thanks,
David
