Trimming during MC runs and getting results

Hello Everyone,

I am new to Ocean script and i need some help in this regard.

I have the following problem.

1. I have a Bandgap circuit in which i need to first run a MC simulation , with in that MC run 
   1. i need to first calculate the DC op point. (untrimmed Bandgap)
   2. Than i need to trim the band gap at room temp
   3. get the result out of trim code and apply it to the design variable.

Run MC over temperature again to get the Bandgap temperature variation

So my question is how to do it. i know i need a for loop but how do i get the results out and how it the flow or sequence of flow should be.

Any help would be great

regards